#Intex infie 3 flash file software#
Information about additional software and hardware features of the rear camera which improve its overall performance.įront camera Modern smartphones have one or more front cameras and their positioning has led to various design concepts – pop-up camera, rotating camera, notch, punch hole, under-display camera, etc. Some of the main standard frame rates for recording and playing video are 24 fps, 25 fps, 30 fps, 60 fps. Information about the maximum number of frames per second (fps) supported by the rear camera while recording video at the maximum resolution. Information about the maximum resolution at which the rear camera can shoot videos. It states the number of pixels on the horizontal and vertical dimensions of the image, which can also be shown in megapixels that indicate the approximate number of pixels in millions. One of the main characteristics of the cameras is their image resolution. It may arrive in a single, dual- or multi-light setup and in different arrangements. The rear cameras of mobile devices use mainly a LED flash. Usually, the f-stop number specified is the one that corresponds to the maximum possible diaphragm opening. The lower the f-stop number, the larger the diaphragm opening is, hence, the more light reaches the sensor. The aperture (f-stop number) indicates the size of the lens diaphragm opening, which controls the amount of light reaching the image sensor. Some of the most widely used types of image sensors on mobile devices are CMOS, BSI, ISOCELL, etc. Information about the sensor type of the camera. Rear camera The primary camera of the mobile device is usually placed on its back and can be combined with one or more additional cameras. Information about other functions and features of the display. Information about the maximum number of colors the screen can display.
It shows the number of bits used for the color components of one pixel. The color depth of the display is also known as bit depth. The higher the pixel density, the more detailed and clearer is the information displayed on the screen. Information about the number of pixels per centimeter (ppcm) or per inch (ppi) of the display. The higher the resolution is, the greater the detail of the displayed content. The display resolution shows the number of pixels on the horizontal and vertical side of the screen.
The ratio between the long and the short side of the display In mobile devices display size is represented by the length of its diagonal measured in inches. One of the main characteristics of the display is its type/technology, on which depends its performance. A further development of the technology is called LTE Advanced.ĭisplay The display of a mobile device is characterized by its technology, resolution, pixel density, diagonal length, color depth, etc. It has been developed by the 3GPP based on the GSM/EDGE and UMTS/HSPA technologies in order to increase the speed and capacity of wireless data networks. LTE is deemed to be the fourth generation (4G) of mobile communications technology. The standard provides faster data transfer speeds and allows more users to connect to the network simultaneously. It is one of the three different UMTS interfaces together with the TD-SCDMA and the TD-CDMA.
#Intex infie 3 flash file code#
W-CDMA (Wideband Code Division Multiple Access) is an air interface used by 3G mobile networks. It has been improved with the addition of General Packet Radio Services (GPRS) and later via the Enhanced Data rates for GSM Evolution (EDGE) technology. GSM (Global System for Mobile Communications) was developed to replace the analog cellular network (1G), therefore it is referred to as a 2G mobile network. Networks A mobile (cellular) network is a radio system, which allows a large number of mobile devices to communicate with each other.
0 kommentar(er)
